That would result in losing all your dataĮxit bios configuration menu and continues with system startup. * n - boot from NAND, if fail then Ethernetģ - boot Flash Configure Mode once, then NANDĭo you realy want to format your storage device? Select key which will enter setup on boot: Hitting the appropriate keyboard letter will give you a list of further options, they are shown below: # d - boot delay: Select which bootloader to use by default Refer to the Partitions document for more infoĬhoose an active partition from which to try to load RouterOSĪllows upgrading RouterBOOT version through the network, or the XModem protocol Warning, no confirmation!ĭestroys all data on the NAND, including RouterOS configuration and license Suppresses all output on the serial port, in case some device is connected to it (like a GPS device or a temperature monitor) The button that will open the configuration menu This example shows the menu which is available in RouterBOOT 7.4beta4:ĭelays starting of RouterOS to allow an interface to initialize We suggest disabling the hardware flow control. RouterBOARD serial port is configured to 115200bit/s, 8 data bits, 1 stop bit, and no parity. The required cable is described in the Serial Console manual. Configurationįor RouterBOARD devices that feature a serial console connector, it is possible to access the RouterBOOT loader configuration menu. The reset button has the same functionality as on other devices, explained in detail ĥ-second button hold on startup (USR LED light starts flashing) - resets to password-protected state.ġ0-second button hold on startup (USR LED turns solid after flashing) - completely removes configuration. Configuration Reset For Wireless Wire kits To do the above actions without loading the backup loader, push the button right after applying power to the device. Then after it has updated and rebooted, I go to System > Scheduler. This sets the update channel to stable for the script. If you hold the button before applying power, backup RouterBOOT will be used in addition to all the above actions. In Winbox: Quick Set > Check For Updates > Channel: Stable.
0 Comments
Leave a Reply. |